Community > Discussion Forum > give a thickness to a geometry

Discussion Forum

give a thickness to a geometry

Topics: no topics

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   1 Reply   Last post: August 25, 2010 1:39pm UTC
maral hassani

maral hassani

August 25, 2010 11:44am UTC

give a thickness to a geometry

hi everybody
I made the geometry in CATIA and then imported it to comsol.I want to know if there is a way Ito give a thickness to the geometry(that is 3D,curved tube like)..
any help?
thanx
maral

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

0 votes
Ivar Kjelberg

Ivar Kjelberg
Moderator

August 25, 2010 1:39pm UTC in response to maral hassani

Re: give a thickness to a geometry

Hi

If you have imported a 2D geometry into COMSOL, you can embed, extrude, or revolve it into 3D
this is still slightly version dependent in V4, probably fully impelemneted again in next version (hope so ;)

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines