Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"grooved/finned" surface

Please login with a confirmed email address before reporting spam

Hi everyone! I'm trying to make "grooved/finned" inside-surface on one of my pipe-model, but i have little difficulties here. Could someone help me with this geometry-problem?

I have just add two geometries (cylindrical&helix) and before i even start to do mesh i got error message below: "Error_in_parameter_domain_topological_analysis".

-Antti

1 Reply Last Post 17.11.2011, 01:37 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 17.11.2011, 01:37 GMT-5
Hi

toroidal, or twisted volumes are delicate to express. be sure you geometry relative feature size is adequate, that your volume do not self interact, and that the meshing will not self-interact. You need fine enough mesh density to resolve correctly the geometrical curvature. I do not know of other things that can go wrong ;)

--
Good luck
Ivar
Hi toroidal, or twisted volumes are delicate to express. be sure you geometry relative feature size is adequate, that your volume do not self interact, and that the meshing will not self-interact. You need fine enough mesh density to resolve correctly the geometrical curvature. I do not know of other things that can go wrong ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.