Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

phase of the wave

Posted 01.02.2012, 06:41 GMT-5 RF & Microwave Engineering Version 4.2 1 Reply

amin khan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I want to extract the phase information from the 2 port S-parameters for a plane wave normally incident on my scattering object. If my incident wave is originated from port 1 with (input phase=0) and received at port 2 having the scattering object in the middle.

Thanks,
1 Reply Last Post 01.02.2012, 07:47 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 01.02.2012, 07:47 GMT-5
Hi

check the doc for the wortd "phasor" COMSOL shows mostly the real part, but many variables are complex so you can look at the imag() and the real() entities. New features have appeared in 4.2a to dedozble the complex variables, butI havnt looked into these yet

--
Good luck
Ivar
Hi check the doc for the wortd "phasor" COMSOL shows mostly the real part, but many variables are complex so you can look at the imag() and the real() entities. New features have appeared in 4.2a to dedozble the complex variables, butI havnt looked into these yet -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content