Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Separating two material

Please login with a confirmed email address before reporting spam

Hello, i am working with transient moving mesh node with two domains.

And i want to simulate,

1. Firstly, two materials were moving same velocity and direction with connected at boundary

2. Then after 1 second, the one material stopped and the other material moved. So, they are separated.

But I found that the mesh at connected boundary of stopped material followed to the moving material.(plz check the attached file)

I think both material were defined as moving with ' prescried mesh velocity'

I want to separate those materials each other.

Anyone can help?

Thanks


1 Reply Last Post 14.03.2012, 02:43 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14.03.2012, 02:43 GMT-4
Hi

you are asking for a change in topology that cannot be easily done with a mesh and certainly not in union mode, some phase change methode or clever use of assembly mode should do. Check the doc

--
Good luck
Ivar
Hi you are asking for a change in topology that cannot be easily done with a mesh and certainly not in union mode, some phase change methode or clever use of assembly mode should do. Check the doc -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.