Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Can i make my design a bit "fluid"?

Please login with a confirmed email address before reporting spam

Dear all senior member here,

Im kinda new with the product. im planning on simulate the electromagnetic flux later from butted & mitred joints.

But first, when im trying to design the butted model, the form is in zig-zag stacking method, i managed to create the model, but it seems stiff and looked not touching each others.

Is there an options in comsol that can make my design snap into the joint surface? thanks in advance



0 Replies Last Post 07.05.2023, 04:57 GMT-4
COMSOL Moderator

Hello Adolf Grekhovsky

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.