"The solution number is out of range" again

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


[start here] Why does COMSOL never respond or fix this common problem

The simulation runs fine. If, howeve, you save it when you are done. It deles all of the data and leaves you with the error message "The solution number is out of range."


1 Reply Last Post 12.03.2024, 13:38 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 months ago 12.03.2024, 13:38 GMT-4
Updated: 2 months ago 12.03.2024, 13:37 GMT-4

Hello Timothy,

To seek assistance from COMSOL employees, please contact support@comsol.com. While some COMSOL employees occasionally contribute to the Discussion Forum, the Forum is intended as a means to initiate conversations among users of the software, not with COMSOL's support team.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello Timothy, To seek assistance from COMSOL employees, please contact support@comsol.com. While some COMSOL employees occasionally contribute to the Discussion Forum, the Forum is intended as a means to initiate conversations among users of the software, not with COMSOL's support team. Best regards, Jeff

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.