Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

creating a thin curved surface Version 3.4

Posted 19.08.2010, 17:24 GMT-4 0 Replies

filippo posta
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to build a model of a cornea to study its behavior under loads. At first all I need to do is to create a thin shell representing the cornea. I have version 3.4 from my advisor, that I access remotely. As of now to create the shell I first draw two concentric spheres that I subtract from each other to obtain a spherical shell of required thickness. The I create a block that is big enough that when I subtact it from my spherical shell I obtain the final thin shell representing the cornea.
I havte two questions:
-Is there a simpler, more efficient way to do this?
- If I want to apply a load on top of the shell, and I want this load to affect a specific area (not an edge or point), how do I do this?

Thanks for you help,
Filippo
0 Replies Last Post 19.08.2010, 17:24 GMT-4
COMSOL Moderator

Hello filippo posta

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content