Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

input Power

Please login with a confirmed email address before reporting spam

Hello, I am simulated a photonic crystal directional coupler of the wave optics module in the frequency domain. my host is switching normally, but I can not change the input power or better make the input power change in the exiting portion, but the results do not change. I was able to switch between the guides using a range of frequencies. But I need a result with respect to output power. what should I do?


1 Reply Last Post 21.03.2018, 03:16 GMT-4
COMSOL Moderator

Hello Elizete Sabino

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 6 years ago 21.03.2018, 03:16 GMT-4

hello, Did you get the solution of your above question.. Actually I am also facing similar type of problem regarding the input power

hello, Did you get the solution of your above question.. Actually I am also facing similar type of problem regarding the input power

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.