Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Help! I cannot bulid the PML in 3D RFmodel-Dipole

Posted 19.03.2010, 16:25 GMT-4 1 Reply

Cheng Ling
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I just follow the DipoleTutorail step by step ...
and I just cannot get the same result in sild 29.

The comsol shows
Error:4125
Invalid topology of subdomain
-subdomain 1

Thank you!
1 Reply Last Post 19.03.2010, 17:28 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19.03.2010, 17:28 GMT-4
Hi

take a closer look at your subdomain "1", and check carefully if its a regular shape, without any overlaps or holes in any corners, where the lines might not close.

A subdomain must be properly closed, and topologically "clean"

Good luck
Ivar
Hi take a closer look at your subdomain "1", and check carefully if its a regular shape, without any overlaps or holes in any corners, where the lines might not close. A subdomain must be properly closed, and topologically "clean" Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content