Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
rms current and solver.
Posted 05.05.2010, 13:07 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
i have simple question; in the tutorial: skin depth on a cylinder; the surface current is applied on the surface with : J=-Itot/2piR,
what is Itot, is it Ipeak or Irms. i expect it is the peak current.
- also for a transient problem; i have to run for 10 s and the time step is 1mus. so the memory required to solve it is huge. Is there a prefered solver?
Regards
benjamin
i have simple question; in the tutorial: skin depth on a cylinder; the surface current is applied on the surface with : J=-Itot/2piR,
what is Itot, is it Ipeak or Irms. i expect it is the peak current.
- also for a transient problem; i have to run for 10 s and the time step is 1mus. so the memory required to solve it is huge. Is there a prefered solver?
Regards
benjamin
1 Reply Last Post 05.05.2010, 14:52 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I'm not sure I understand you well, and I'm neither not sure I have the correct reference for your current model you talk about, but if you are in the "harmonic" mode then you develop the signals as amplitudes and phase of a "sinus" type wave of refequency "nu". Therefore it is the amplitude (0 to peak) and not the rms value, I believe you should refer to. THe bebst is to take a very simple known case and run that, so tat you can easily cross check with an analytical equation
Second if you have a 1 us step to resolve your case, I wounder why you need to continue to 10sec total, that is 1:10^6 quite a range. But again it depends on the physics you are modelling. Still my first thought is that you could probabaly simplify the model by considereing a harmonic development rather than a fully transient time dependent.
Hope it helps on the way
Have fun Comsoling
Ivar
I'm not sure I understand you well, and I'm neither not sure I have the correct reference for your current model you talk about, but if you are in the "harmonic" mode then you develop the signals as amplitudes and phase of a "sinus" type wave of refequency "nu". Therefore it is the amplitude (0 to peak) and not the rms value, I believe you should refer to. THe bebst is to take a very simple known case and run that, so tat you can easily cross check with an analytical equation
Second if you have a 1 us step to resolve your case, I wounder why you need to continue to 10sec total, that is 1:10^6 quite a range. But again it depends on the physics you are modelling. Still my first thought is that you could probabaly simplify the model by considereing a harmonic development rather than a fully transient time dependent.
Hope it helps on the way
Have fun Comsoling
Ivar