Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to get time-varing points coordinates on a moving boundary in time dependent analysis?

Please login with a confirmed email address before reporting spam

Hi, I am now encountering a problem. My simulation uses NS application mode. Some boundaries will moving with the pressure, so the ALE appl mode is also used. Now because the pressure has related with the curvature of these moving boundaries, so I tried to seed many points on the boundary. Thus, through using the points coordinates, the curvature could be calculated through difference method. And the pressure relating with the curvature is configured in the boundary settings.

I use the function "geominfo" to get coordinates of the points in MATLAB script, but find out that the curvature did not change with the moving boundary.

I tried hard but failed.

Looking forward to reply!

Thank you very much!

0 Replies Last Post 15.09.2010, 23:12 GMT-4
COMSOL Moderator

Hello Yuanyuan Shen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.