Mg_h 18[mm] "Magnet height"
S_r 20[mm] "Shaft radius"
M_w 10[mm] "Magnet width"
A_g 2[mm] "Air gap between stator and slider"
St_h 8[mm] "Stator tooth height"
Sl_h 23[mm] "Slider tooth height"
P_P 2*Mg_h+2*Sl_ch "Pole pitch"
Sl_ch 15[mm] "Slider iron height"
Sl_tw 4[mm] "Slider tooth width"
C_h (P_P-3*St_h)/3 "Coil height"
St_w 4[mm] "Stator tooth width"
C_w 10[mm] "Coil width"
St_ith 5[mm] "Stator back-iron thickness"
Nturns 100 "Number of coil turns in each winding"
speed 1[m/s] "Speed of the rotor"
filling_factor 0.8 "Filling factor"