
Browse by Category
 All Solutions
 ALE / Parameterized Geometry (1)
 Error Messages (59)
 Export (1)
 Fluid Dynamics (1)
 General (11)
 Geometry (11)
 Import (9)
 Installation (33)
 Mesh (12)
 Multiphysics (1)
 Physics (10)
 Postprocessing (4)
 Product Information (1)
 Solver (30)
 Structural Mechanics (2)
Solution Number:  1257 
Title:  Solving electromagnetic heating models with highfrequency loads 
Platform:  
Categories:  General, General 
Keywords: 
Problem Description
I am solving a Multiphysics problem involving electromagnetics and heat transfer. The electromagnetic fields are varying at a constant frequency, and the period is very short compared to the timespan over which the system heats up. In addition, the electrical properties are a function of the changing temperature over time. How should I set up such problems efficiently?
Solution
Background
Many Multiphysics problems involve physics that have different characteristic timescales. One of the most common cases is electrothermal heating. For example, consider a heater connected to the electrical grid. The applied voltage is varying at 60Hz but you may want to simulate the heating over several minutes, or longer. In addition, the electrical material properties are temperaturedependent, and thus the electromagnetic field solution will vary as the system heats up. However, solving for both of these governing equations in the timedomain would be very timeconsuming, and is almost certainly unnecessary.
Solution
When the electromagnetic loads and the solution fields are sinusoidally varying (or very nearly so) over a single cycle, then one does not need to solve a timedomain problem for that physics. Instead, the electromagnetic fields can be solved in the frequencydomain, which assumes that the material properties are constant over one cycle, that the solution fields are timeharmonic. Under these assumptions the electromagnetic physics can be solved as a stationary problem with relatively little computational effort, while still solving for the timeevolution of the temperature fields.
The Multiphysics branch with the Electromagentic Heating feature considers the cycleaveraged loads.
First, you must have an Electromagnetic Heating feature within the Multiphysics branch of your Model Tree, as shown in the screenshot above. Then, add a FrequencyTransient study type to your Multiphysics model. This study type is only available when the correct Multiphysics coupling feature is on the model. Any electromagnetic interface from the AC/DC, MEMS, RF or Wave Optics Modules is supported by this study type.
The various Multiphysics study types that will solve a frequencydomain electromagnetic problem with a stationary or transient thermal problem.
If you instead want to make the simplifying assumption that the electromagnetic field solution does not depend upon the temperature field at all, then instead use the Sequential FrequencyTransient Study type. The study will first solve the electromagnetic problem, and then the transient heat transfer problem in a following study step.
If you are solving for the steadystate temperature fields, you can use the FrequencyStationary study type. This study will incorporate the temperaturedependent material properties in the electromagnetic analysis. You can also use the Sequential FrequencyStationary study type to solve first the frequencydomain electromagnetic problem, and then the stationary thermal problem.
Disclaimer
COMSOL makes every reasonable effort to verify the information you view on this page. Resources and documents are provided for your information only, and COMSOL makes no explicit or implied claims to their validity. COMSOL does not assume any legal liability for the accuracy of the data disclosed. Any trademarks referenced in this document are the property of their respective owners. Consult your product manuals for complete trademark details.