Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Difficulty in selecting geometry for boundary condition in a magnetostrictive model.

Please login with a confirmed email address before reporting spam

Hello everyone, I am working on a magnetostrictive model which is a solid cube and I want to apply periodicity as a boundary condition to vertex to the opposite vertex, edge to opposite edge, and face to opposite face. When I select periodicity as boundary condition it just allows me to select boundaries of the model which are basically faces of the cube. I could apply this boundary conditions in ABAQUS by using a matlab code but I am unable to do it in COMSOL. Is there any way I can select geometry according to my requirement mentioned above??


2 Replies Last Post 18.06.2019, 14:56 GMT-4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 14.06.2019, 03:50 GMT-4
Updated: 5 years ago 14.06.2019, 03:50 GMT-4

Hi,

Can you supply a sketch? What is the physical background? It is not clear what differentiates the edge and vertex conditions from the boundary conditions.

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi, Can you supply a sketch? What is the physical background? It is not clear what differentiates the edge and vertex conditions from the boundary conditions. Regards, Henrik

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 18.06.2019, 14:56 GMT-4
Updated: 5 years ago 18.06.2019, 14:51 GMT-4

I have attached the sketch of the model that I have been working on. The notations A, AA, B, BB, C, CC, D, DD are vertex points. Notations ZM, ZP, XP, XM are surfaces of the model. the notations U, V, W, S, WW, T, R, SS, UU, RR, TT, VV are the edges of the model. The other image provided explains the type of BCs that has to be applied to the model.

I have attached the sketch of the model that I have been working on. The notations A, AA, B, BB, C, CC, D, DD are vertex points. Notations ZM, ZP, XP, XM are surfaces of the model. the notations U, V, W, S, WW, T, R, SS, UU, RR, TT, VV are the edges of the model. The other image provided explains the type of BCs that has to be applied to the model.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.