Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Freeze drying (sublimation) of a sphere

Please login with a confirmed email address before reporting spam

Hi I need some insight into how would you guys start a freeze-drying simulation with an spherical geometry. I tried following the tutorial offered in the comunity (in that case it was a vial) modifying the geometry and certain conditions (considered that the particle transfered mass in all of its surface) but it always tells me I reached a singularity error at around 70 minutes. I used deformed geometry with darcy flow and heat transfer both in porous media.


0 Replies Last Post 01.12.2020, 13:07 GMT-5
COMSOL Moderator

Hello Antonio Clemente

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.