Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

WorkPlane

Please login with a confirmed email address before reporting spam

Hi! I hope that you fine! I would like about the simulation of coils 3D. I need to build the simulation using coils not planars, so in this case can I use only the Workplane? Because when I try the incializate of the simulation a mistake to appear about the boundary conditions, especifically the perfect eletric conductor, that need two conditions. However, in simulation 3D there are most regions to define.

Thanks


0 Replies Last Post 23.08.2023, 18:11 GMT-4
COMSOL Moderator

Hello Igor Oliveira Souza

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.