Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Two phase Phase field method

Please login with a confirmed email address before reporting spam

Hi,

I am using a phase field method to tract the meniscus formation at the exit of a micron size nozzle and at the same time air is flowing over the meniscus. I am having some problems with the solution, when i use real values of the viscosities i.e (0.007Pa.s and 2e-5Pa.s) for the two fluids i get no solution at all, however when i increase the values of the viscosities by 100 i get physically meaningful results but if i increase them by only 10 i can not observe any change in the meniscus growth after a certain point. I have even increased the simulation time to verify this but the meniscus does not change after a certain point.


0 Replies Last Post 12.12.2012, 19:42 GMT-5
COMSOL Moderator

Hello Sin Kim

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.