Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to execute file1.mph, file2.mph, and file3.mph one by one?

Please login with a confirmed email address before reporting spam

Hi everyone

If I have many mph files (the mesh has done), how to ...

open file1.mph > solve > save > close > open file2.mph > solve > save > close > ... automatically

Thanks!

2 Replies Last Post 01.03.2010, 22:22 GMT-5
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28.02.2010, 21:30 GMT-5
You can do this one at a time using the batch feature of comsol. Version 4 will make this easier to use, but it is also available now in v3.5a. Look up the batch command in the manual and also "comsol batch -h"
You can do this one at a time using the batch feature of comsol. Version 4 will make this easier to use, but it is also available now in v3.5a. Look up the batch command in the manual and also "comsol batch -h"

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 01.03.2010, 22:22 GMT-5
Thank you so much.

I got it.
Thank you so much. I got it.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.