COMSOL modelling of magnetron antenna in launcher waveguide

Please login with a confirmed email address before reporting spam

Dear all,

After reading the following post, I would still have a question, please: https://www.comsol.com/forum/thread/344681/modeling-magnetron-antenna-connected-to-rectangular-waveguide

In the case I wish to model only the waveguide launcher and the magnetron antenna (the waveguide launcher whose picture has been attached in the previous post would be the furnace/resonant cavity itself where I would include some liquid to heat, small cube in my snapshot), how should I model the magnetron antenna? As far as I understood, it should be a coaxial port in the RF module, but not sure how to set the boundaries (please see attached picture, MPH file too big).

Thanks in advance,

Kind regards,

Fabio A.



1 Reply Last Post 15.05.2025, 11:15 GMT-4
Robert Koslover Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 18 hours ago 15.05.2025, 11:15 GMT-4

See https://www.comsol.com/model/coaxial-to-waveguide-coupling-1863 .

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
See https://www.comsol.com/model/coaxial-to-waveguide-coupling-1863 .

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.