Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
What should I do 3 phase Generator 2D in Model library
Posted 22.08.2010, 23:29 GMT-4 7 Replies
Please login with a confirmed email address before reporting spam
This example is the single phase Gen.
If the single phase Gen can be three phase Gen, How to improve or apply it
Vi=NN * L (integration(Ez.dA)) / A
This eq from
And the Eq can be use with three phase or not
What is the principle to definte Vi
Thanks you in advance
i sas
Hello I Sas
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
i'm simulating also 3 phase motor (U, V and W) and using this
ViU= mod1.intopUp(L*rmm.Ez/A)-mod1.intopUn(L*rmm.Ez/A)
mod1.intopUp ist integration of U phase wire that goes -p for positive, -n for negative
ViV=mod1.intopVp(L*rmm.Ez/A)-mod1.intopVn(L*rmm.Ez/A)
ViW=mod1.intopWp(L*rmm.Ez/A)-mod1.intopWn(L*rmm.Ez/A)
it's just worked (it solved. i havent evaluate the result, but maybe...
regards
akmal
Please login with a confirmed email address before reporting spam
if you have 3 phases at 120° dephasing, you probably have a "phasor" term and should consider the real and imaginary parts, no ?
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
I am trying to simulate the 3-phase induction motor, but i do not know how to deal with the phase A, B , and C
can you help me please
Thanks
Natheer
Please login with a confirmed email address before reporting spam
it is a perfect example from Floris van Kempen. please try to evaluate it.
www.ch.comsol.com/community/forums/4-1/thread/19133/
www.ch.comsol.com/community/forums/4-1/download/file/7889/pm_motor_no_solutions.mph
regards
akmal
Please login with a confirmed email address before reporting spam
I have COMSOL 3.5, and I think the model is made on COMSOL 4.1.
I can not open it !!!!
Is there any idea ???
Also I am trying to simulate the induction machine, but the software can not mesh one part.
Can you help me how to mesh it manually ?? or any idea to overcome this problem.
you can write to me directly to my email
natheer80@yahoo.com
Regards
Please login with a confirmed email address before reporting spam
I have already solved the problem of mesh
but still i do not know exactly how i should deal with phases ?!!!
I tried to inject the windings by current density J varies with time , is that correct ????
Please reply to this
Natheer
natheer80@yahoo.com
Please login with a confirmed email address before reporting spam
I am simulating 3D axial flux permanent magnet generator using comsol 4.3, i am having trouble in plotting time dependent voltage curve. In model library there is a 2d generator example which has used formula below for the induced voltage in the windings:
"mod1.intop1(L*rmm.Ez/A)- mod1.intop2(L*rmm.Ez/A)"
where, L is length of generator, A is area of coil
But I donot understand this formula, how this works??
In my opinion both the terms are equal and result must be zero.
Please, anyone can explain how this work.
Thank you.