Sehen Sie, wie die Multiphysik-Simulation in verschiedenen Branchen eingesetzt wird
Multiphysik-Modellierung und -Simulation treiben Innovationen in Industrie und Wissenschaft voran – wie die zahlreichen Anwendungsbeispiele zeigen, die jedes Jahr in den Fachbeiträgen und Postern von Ingenieuren, Forschern und Wissenschaftlern auf der COMSOL Conference vorgestellt werden. Lassen Sie sich von den unten aufgeführten aktuellen Beiträgen inspirieren oder nutzen Sie die Schnellsuche, um eine bestimmte Präsentation zu finden oder nach Anwendungsbereich oder Konferenzjahr/-ort zu filtern.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
It is a complex problem to calculate the photonic crystal fiber model, and the methods of plane wave expansion, Hermite-Guasssian function and beam propagation have been analyzed. Finally the multipole method is adopted for solving problem. The hexagonal air holes in cladding have been ... Mehr lesen
Accelerometers are successfully commercialized MEMS devices. COMSOL Multiphysics® has been used in the modeling, simulation and optimizing of this design. The piezoresistive accelerometer is made up of a square proof mass with flexures supporting it. The piezoresistors are placed near ... Mehr lesen
Project X is a proposed proton accelerator complex at Fermilab. The CW LINAC is based on five types of resonators operating at three frequencies: half-wave, spoke, and elliptical. The low beam current for the CW operation of Project X requires cavities to operate at a high loaded Q and, ... Mehr lesen
Deep Ultraviolet Light Emitting Diodes (DUV LEDs) are presently operating at a relatively low efficiency, thus large amount of LED driving power is dissipating in heat. Thermal heating degrades LED performance and decreases LED’s lifetime. The degradation of DUV LED devices with ... Mehr lesen
We simulate a Capacitive Micromachined Ultrasound Transducer (CMUT) using COMSOL Multiphysics® software. The CMUT is an electromechanical system, therefore, we couple the physics of electrical and structural mechanics to describe its dynamics. We obtain the distributions of the electric ... Mehr lesen
Magneto-Hydrodynamic (MHD) power generation systems were originally investigated starting from the fact that the interaction of a plasma with a magnetic field must take place at much higher temperatures than could be observed in a mechanical turbine. The main problems of traditional MHD ... Mehr lesen
This paper describes a model of self-ventilated generator cooling on a 170 tons off-road mine dump truck. Considering the space restrictions of mine dump truck, the cooling systems for the generator and the in-wheel motors of the rear axle share one air inlet duct. With the action of ... Mehr lesen
Metamaterial [1, 2] is an artificially structured material where it’s electrical (ϵ), magnetic (μ) and its refraction properties (n) are simultaneously negative in narrow frequency band. Currently, metamaterials are being widely used in microwave and radio frequencies as devices [3, 4] ... Mehr lesen
SAFARI is a far-infrared imaging spectrometer for the Japanese satellite observatory SPICA. SAFARI covers the wavelength range 34—210 μm (1.4—8.8 THz) using Transition-Edge-Sensor (TES) bolometers. We have built a test facility to qualify and characterize the SAFARI focal plane units ... Mehr lesen
Introduction: Chronic arterial hypertension (HTN) is a pathological condition characterized by prolonged high level of arterial blood pressure causing major damages to several human body apparata. Renal sympathetic denervation (RDN) has been found to effectively reduce systemic blood ... Mehr lesen