Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
Delayed Coking is a refining process, which takes heavy petroleum residue as a feed. A 2D axisymmetric stationary model was created to simulate this pre-run condition with nitrogen gas, as an attempt to calibrate the model before simulating with an oil residue. The single-phase laminar ... Mehr lesen
Electric, magnetic and electromagnetic (em) methods are widely used to monitor active volcanoes. A review of such applications is presented in Johnston (cit). Em signals were recorded in correspondence of numerous volcanic eruptions, for example in the case of the Mt. Unzen in Giapppone, ... Mehr lesen
In-situ electrical heating technologies are among the most recent technologies used for bitumen recovery from tar sand and oil shale. These technologies have limited environmental impact because there is little disturbance of the land, and water and solvents are not used. Two-phase ... Mehr lesen
The blast furnace hearth drainage constitutes a major part of the blast furnace operation. Especially, keeping track of the iron and slag levels is crucial to adapt the tapping strategy. The operational target is usually not only to empty the blast furnace as far as possible but also to ... Mehr lesen
Introduction Droplet-based microfluidics is a large source of research for scientists of new biotechnologies, aerosols or other 2D-Microfluidics devices. Here, we will focus on an industrial application of a 3D microfluidic device : the PH2DG, Pneumo-HydroDynamic Droplet Generator. The ... Mehr lesen
To maintain same droplet size across parallel devices, new break-up strategies based on geometry are been studied. In this work, we model a geometrically-set droplet generator, in which the droplet break-up occurs by a block and break mechanism. In other words when the disperse phase ... Mehr lesen
Verification of the codes applied for assessment of the long-term repository safety is typically one of the quality assurance requirements demanded by regulatory bodies, in the disposal of radioactive waste. In this paper, an internationally organized benchmark exercise is presented, in ... Mehr lesen
Introduction Velocity profiles in liquid films flowing over rotating conical surfaces are of considerable interest in industry. The efficiency of important process equipment, such as spinning cone columns, fluid degassers, centrifugal disc atomizers, centrifugal film evaporators, and ... Mehr lesen
Wettability affects two-phase displacements in porous media by determining the microscopic distribution of fluids in pore spaces. The impact of wettability on transport properties at macro-scales has been widely addressed in literature; however a deeper understanding of wettability ... Mehr lesen
Disposal in deep clay geological formations is one of the promising options for disposal of high-level radioactive waste. Yet, they can generate considerable amounts of heat as a side effect of radioactive decay. This paper shows how COMSOL Multiphysics has been used to evaluate the ... Mehr lesen