Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
This work describes the design and optimization of three prototypes of microelectromechanical systems (MEMS) capacitive accelerometer-based middle ear microphone. The microphone is intended for middle ear hearing aids as well as future fully implantable cochlear prosthesis. The analysis ... Mehr lesen
We are working on a microfabricated lysing chip that uses a piezoelectric actuator to provide ultrasonic energy to break apart cells. The device contains pillars with varying dimensions. We hypothesize that increasing the aspect ratio of pillars will increase the efficiency of the ... Mehr lesen
Prof. Jeng-Shian Chang received his B.Ec. degree (1974) in Mechanical Engineering from National Taiwan University, Taipei, Taiwan, and M.Sc. degree (1981) in Mechanical Engineering and M.Sc. degree (1983) in Computer Science both from Syracuse University, USA. In 1984 he received the Ph ... Mehr lesen
We use finite elements simulations in order to study the fluid flow behavior in a chamber of a preconcentrator. We realized that most part of the fluid does not affect our preconcentrator because it is going out the chamber at high distance above it and parallel to the preconcentrator. ... Mehr lesen
Vibrating mechanical tank components, such as quartz crystals and surface acoustic wave (SAW) resonators with Q’s in the range of 10e3–10e6, are widely used to implement high-Q oscillators and band pass filters in the radio frequency (RF) and intermediate frequency (IF) stages of ... Mehr lesen
Introduction: Vibration energy harvester can convert mechanical vibration energy into electrical energy and store it in battery for later use. It can create clean renewable energy from vibration movements such as walking, jumping, running, etc. This can convert energy previously wasted ... Mehr lesen
Three-dimensional FEM method provided by COMSOL is used to model an inhomogeneous advanced breast tumor of different optical properties for outer layer and inner core in a semi-infinite medium. The running time of FEM by COMSOL for one source and 14 detectors is 17.658s and which of ... Mehr lesen
The micro machining technology that emerged in the late 1980’s can provide micron sized sensors and actuators. Actuators are used for the transformation of non- mechanical input energy into mechanical output energy. There are many types of micro- actuation mechanisms, most commonly used ... Mehr lesen
The High Flux Isotope Reactor, located at the Oak Ridge National Laboratory, is scheduled to undergo a conversion of the fuel used and this proposed change requires an extensive analysis of the flow through the reactor core. The core consists of approximately 500 very thin and long fuel ... Mehr lesen
Articular cartilage is composed by a charged solid matrix (proteoglycan and collagen fibres) and an interstitial fluid phase. The permeability of articular cartilage is a function of compression load applied on the tissue, the solid matrix underwent a compaction that decreased its value ... Mehr lesen
