Veröffentlichungen und Präsentationen

Schnellsuche

Ressourcen

Whitepaper

Sehen Sie, wie die Multiphysik-Simulation weltweit in der Forschung eingesetzt wird

Multiphysik-Modellierung und -Simulation treiben Innovationen in Industrie und Wissenschaft voran – wie die zahlreichen Anwendungsbeispiele zeigen, die jedes Jahr in den Fachbeiträgen und Postern von Ingenieuren, Forschern und Wissenschaftlern auf der COMSOL Conference vorgestellt werden. Lassen Sie sich von den unten aufgeführten aktuellen Beiträgen inspirieren oder nutzen Sie die Schnellsuche, um eine bestimmte Präsentation zu finden oder nach Anwendungsbereich oder Konferenzjahr/-ort zu filtern.

Sehen Sie sich die Sammlung für die COMSOL Conference 2026 an

Statistical Modeling and Contact Analysis of RF MEMS Surface

J. Liu [1], V. B. Chalivendra [1], C. Goldsmith [2], W. Huang [1],
[1] Department of Mechanical Engineering, University of Massachusetts - Dartmouth, Dartmouth, MA, USA
[2] MEMtronics Corporation, Richardson, TX, USA

Radio frequency (RF) micro-electro mechanical system(MEMS) switch works in on/off modes controlled by electrostatic forces. In off mode, rough surfaces of electrodes come into a contact to shunt the RF signal. Surface contact area has been recognized as a key factor in RF MEMS ... Mehr lesen

CFD Analysis of a Printed Circuit Heat Exchanger

K. Wegman [1], X. Sun [1],
[1] Department of Mechanical and Aerospace Engineering, Ohio State University, Columbus, OH, USA

In this experiment, the performance of a Printed Circuit Heat Exchanger (PCHE) was studied using COMSOL Multiphysics® software. PCHEs are diffusion bonded heat exchangers containing semicircular, chemically etched flow paths. Helium was used as the working fluid on both the hot and cold ... Mehr lesen

Infrasound Assessment of the Roller Compacted Concrete Dam: Case Study of the Portugues Dam in Ponce, PR

H. Diaz-Alvarez [1], V. P. Chiarito [1], S. McComas [1], M. H. McKenna [1],
[1] U.S. Army Engineer Research and Development Center, Vicksburg, MS, USA

The U.S. Army Corps of Engineers is currently investigating the use of infrasound sensors to monitor the health of structures of interest. Infrasound is low-frequency (2-20 Hz) acoustic energy and is capable of propagating many kilometers from the source structure. Large infrastructure, ... Mehr lesen

COMSOL Multiphysics® Automated Installation Verification via LiveLink™ for MATLAB®

M. W. Crowell [1],
[1] Research Reactors Division, Oak Ridge National Laboratory, Oak Ridge, TN, USA

Verifying that a local software installation performs as the developer intends is a potentially time consuming but necessary step for nuclear safety related codes. Automating this process not only saves time, but can increase reliability and scope of verification compared to ‘hand’ ... Mehr lesen

Bridge Scour Detection of the Feather River Bridge in Yuba City, CA through the use of Finite Element Modeling and Infrasound

A. Jordan [1], D. Whitlow [1], S. McComas [1], M. H. McKenna [1],
[1] U.S. Army Engineer Research and Development Center, Vicksburg, MS, USA

Ongoing studies by the US Army Engineer Research and Development Center (ERDC) are investigating infrasound as a means of persistent monitoring and scour detection at bridges through analysis of the frequency change of the structure caused by altered boundary conditions. Bridges ... Mehr lesen

Modeling Conventional Swing of a Cricket Ball

R. Latchman [1], A. Pooransingh [1],
[1] University of the West Indies - St. Augustine, St. Augustine, Trinidad and Tobago

Conventional swing is one phenomenon which a bowler uses to gain an advantage over the batsman. This study involved simulating conventional swing in the CFD Module of COMSOL Multiphysics® software and comparing the simulated results with experimental results of previous researchers. The ... Mehr lesen

Modeling of Stockton University Geothermal System Using COMSOL Multiphysics® and the Subsurface Flow Module

M. Sharobeam [1], S. Pal [1], G. Villanuna [1],
[1] School of Natural Sciences and Mathematics, Stockton University, Galloway, NJ, USA

Stockton University has one of the largest closed loop geothermal system in North America. It provides heating and cooling for the university academic facilities. The well field comprises of a grid of four hundred wells bored to a depth of 130m. The ground is composed of three aquifers ... Mehr lesen

Design and Simulation of MEMS Based Piezoelectric Insulin Micro-Pump

F. Meshkinfam [1],
[1] University of Ontario Institute of Technology, Oshawa, ON, Canada

One of the most effective treatments for diabetes type 1 and 2 is the administering Insulin. The design of positive volumetric insulin pump is significantly a multiphysics problem where the volumetric change of the main pump chamber and the pumped fluid are directly coupled. We used ... Mehr lesen

Erste

3841–3848 of 6555

Letzte