Sehen Sie, wie die Multiphysik-Simulation in verschiedenen Branchen eingesetzt wird
Multiphysik-Modellierung und -Simulation treiben Innovationen in Industrie und Wissenschaft voran – wie die zahlreichen Anwendungsbeispiele zeigen, die jedes Jahr in den Fachbeiträgen und Postern von Ingenieuren, Forschern und Wissenschaftlern auf der COMSOL Conference vorgestellt werden. Lassen Sie sich von den unten aufgeführten aktuellen Beiträgen inspirieren oder nutzen Sie die Schnellsuche, um eine bestimmte Präsentation zu finden oder nach Anwendungsbereich oder Konferenzjahr/-ort zu filtern.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
The maintenance plan or rush-to-repair of a subsea pipeline for oil transport may result in the shutdown of the line, in other words, may stop the flow of fluid. During the shutdown, the temperature of the oil tends to decrease continuously, and the heavy molecules tend to crystallize ... Mehr lesen
Surface discharge at the oil-pressboard interface has been classified as the most dangerous fault condition in power transformer because it results in catastrophic failure under normal operating conditions and difficult to be detected. In order to understand the physical features of ... Mehr lesen
This study presents a model for simulating a subsurface pumped-hydro energy storage (battery) system. The model captures the coupling between fluid flow in an oil and gas type wellbore connected to a large hydraulic fracture embedded in a low-permeability reservoir. By integrating ... Mehr lesen
In this work, a bimetallic strip based thermal sensor was designed using MEMS module of COMSOL Multiphysics® software to monitor the temperature rise in insulating oil which was used as coolant in transformers. The bimetallic strip was designed with different shapes such as cylindrical, ... Mehr lesen
Substances like Mineral Oil Saturated Hydrocarbons (MOSH) and Mineral Oil Aromatic Hydrocarbons (MOAH) are suspected to be carcinogenic. Furthermore, MOSH/MOAH migrate through the packaging into food stuff. This work aims at modelling, how much MOSH/MOAH migrates from the packaging into ... Mehr lesen
Oil and water are immiscible fluids and they tend to separate very easily when introduced into a flow stream from two different sources in a flow loop. This model studies the development of mixture volume fraction in an oil-water-flow loop with 3 different passive mixing schemes: (i) ... Mehr lesen
One of the methods to recover oil from medium and low viscosity in complex reservoirs uses air injection leading to oil combustion. In this case the oxygen in the air burns the heavier components of the oil, generating a heat wave leading to vaporization of lighter components. The ... Mehr lesen
Introduction: Polymer materials are increasingly used in machine elements such as seals and plain bearings. In particular, PEEK has gained attention for use in wind turbine applications due to its strength and resistance to harsh operating conditions. However, its low thermal ... Mehr lesen
In this paper we used COMSOL Multiphysics to model basic physico-chemical effects relevant in polymer enhanced oil recovery (EOR) such as non-Newtonian rheology of the displacing phase, permeability reduction, adsorption and salinity effects. COMSOL\'s PDE interface as well as Species ... Mehr lesen
This study presents a oil-gas two-phase linear flow EMH model using COMSOL Multiphysics simulator. Special attention is focused on reservoirs with characteristics for which steam injection is not attractive or feasible such as low permeability, thin-zone, and extra-heavy oil reservoirs. ... Mehr lesen
