Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulation of nanoparticle adhesion through laminar flow between parallel plates.

Please login with a confirmed email address before reporting spam

Hello everyone,

We are trying to simulate nanoparticle adhesion to substrate(the bottom wall of the rectangular channel, with cylindrical inlet and outlet on the top wall). We are using Laminar Flow(stationary) and Particle Tracing(time dependent) modules and tried stick and probability conditions, but the particles only adhere at the inlet region.

Does anyone know how to add surface roughness at the bottom wall?
We have to compare Structural Mechanics module to model adhesion or any other module? If so, can we compare this module with Laminar Flow and Particle Tracing?

Best regards,
Michalis G.


0 Replies Last Post 05.10.2016, 16:57 GMT-4
COMSOL Moderator

Hello Michalis Georgallas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.