Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Subdividing a domain

Posted 23.03.2011, 16:48 GMT-4 Geometry Version 4.0a 1 Reply

Salvador Gómez Carretero
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everybody!

I have been working with COMSOL 4.0a for some days and I have a newbie question. I was wondering if you could help me. My question is: how can I subdivide a domain in 3D? I think I have managed to do it by defining a workplane (and a plane in 2D inside the workplane) that intersects the domain. Is that the right way to do it?

And how can I subdivide domains in 2D?

Thanks a lot.

Best regards,
Salva
1 Reply Last Post 24.03.2011, 03:14 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24.03.2011, 03:14 GMT-4
Hi

indeed add a plane or a line in 2D, or have two overlapping volumes respective areas

--
Good luck
Ivar
Hi indeed add a plane or a line in 2D, or have two overlapping volumes respective areas -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content