Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Convergence while connection of PSPice circuit

Please login with a confirmed email address before reporting spam

Hello. I simulate two parts in COMSOL. The first is geometry part and the second - created by pspice. They are connected between each other by means of COMSOL tools. During simulation I've got convergence around 3e+8. What does it mean? Are obtained results correct? Where I could got more information about convergence? Thanks for any helping/information.

1 Reply Last Post 25.04.2011, 03:38 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25.04.2011, 03:38 GMT-4
Hi

it does not seem to be very good convergence, in my understanding should tend towards "=0". Perhaps you should check the scaling values, you might get some more info if you turn on the "detailed" log info (v4) or study the log file in 3.5

--
Good luck
Ivar
Hi it does not seem to be very good convergence, in my understanding should tend towards "=0". Perhaps you should check the scaling values, you might get some more info if you turn on the "detailed" log info (v4) or study the log file in 3.5 -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.