Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Very Thin Piezoelectric Layer Modelling

Posted 15.08.2018, 18:12 MESZ Piezoelectric Devices, MEMS & Piezoelectric Devices, Geometry Version 5.3 0 Replies

Sven Kirbach
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I try to model a structure with a piezoelectric layer of just a view nm. Obviously it is only possible to add the "piezoelectric material" node to the structural mechanics interface. I tried it with the "membrane" and the "shell" feature, but there isn´t the "piezoelectric material" node available. Due to the high aspect ratio of the whole structure compared to the PE layer, the layer is neither visible nor selectable for further proceedings. A reduction by using symmetry is not possible too. Has anybody an idea to handle this problem or is it unsolvable?

Thanks for any comment,

Sven

0 Replies Last Post 15.08.2018, 18:12 MESZ
COMSOL Moderator

Hello Sven Kirbach

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content