Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
3D geometry selection comsol 3.5a
Posted 13.07.2011, 12:28 GMT-4 Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 3.5a 0 Replies
Please login with a confirmed email address before reporting spam
Hi,
I am fairly new to comsol and am using the 3.5 version.
My problem,
I have a 3D airfoil and need to specify sections along the chord of the airfoil so I can apply geometry deformations to different areas. In simply terms I need to use the format for
X>(a certain section length) then one set of equations is valid
X<(a certain section length) then another set of equations is valid
where x is the chord length of the airfoil.
Any help would be greatly appreciated.
Regards
Kim
Hello Kim Smith
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.