Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Applying constraint points for welding in assembly

Please login with a confirmed email address before reporting spam

I have searched info for welds, but only found info on modeling the welding process.

I have a welded assembly for a water-cooled part, but not sure how to define constraints properly for the weld points. My goal is to simulate distortion from water pressure. My prior experience with AutoDesk Inventor is you could actually model the type of weld and weld material, but don't see this functionality here. If I added weld material in my Creo 5.0 assembly would that help?

Frankly I would be happy with just getting the weld point constraints correct between the assembly components. Thanks. --m


0 Replies Last Post 15.11.2019, 10:55 GMT-5
COMSOL Moderator

Hello Mike Paisley

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.