Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Membrane Contactor (Liquid-Liquid) - Mass Transfer Rate

Asalia Environmental Engineering

Please login with a confirmed email address before reporting spam

Hello! I am fairly new to COMSOL and would like to ask if any of you had dealt with modeling on membrane contactor (liquid-liquid is preferable or any phases)??

I know that the key point is defining the boundary on the membrane, however I have difficulties in which physics option should I add if I want to specify the mass transfer rate at the interface boundary ?

Thank you so much!

-------------------
-Lia

0 Replies Last Post 02.03.2020, 20:44 GMT-5
COMSOL Moderator

Hello Asalia

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.