Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Derivign Surface Ave Conc in 2D Axisym

Posted 13.07.2012, 09:44 GMT-4 Results & Visualization Version 4.2a 1 Reply

Melanie Pigeon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am wondering if there is any easy method of deriving the average concentration for a surface in a 2d axisymmetrical model. I tried to create a Cut Plane and evaluate the concentration but the memory required are too large. Is there any other method that can be used?
1 Reply Last Post 14.07.2012, 14:39 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14.07.2012, 14:39 GMT-4
Hi

if you are in 2D-Axi you should use a 2D cut LINE in a 2D section view and average over this Data Set, this should work straighforward

--
Good luck
Ivar
Hi if you are in 2D-Axi you should use a 2D cut LINE in a 2D section view and average over this Data Set, this should work straighforward -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content