Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Newbie needs help seting up ramp function as voltage source

Posted 16.10.2012, 11:11 GMT-4 Low-Frequency Electromagnetics Version 4.3a 2 Replies

Peter Sieber
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am new to comsol and cannot figure out how to assign a rect function as the input source to a strip of copper. I subsequently need to study the thermodynamics (which I have successfully done in steady state)

Thanks
2 Replies Last Post 17.10.2012, 10:58 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 17.10.2012, 01:01 GMT-4
Hi

if you are in time dependent case, write V=V0[V]*rect1(t[1/s]) for a ptential defines as per your rectngle function you can make in Model - Define - Functions

--
Good luck
Ivar
Hi if you are in time dependent case, write V=V0[V]*rect1(t[1/s]) for a ptential defines as per your rectngle function you can make in Model - Define - Functions -- Good luck Ivar
Peter Sieber
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 17.10.2012, 10:58 GMT-4
Thanks. Looks like I am missing the AC toolbox
Thanks. Looks like I am missing the AC toolbox

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content