Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
What kind of strain or stress should I be reading in the results for piezoelectric simulation
Posted 26.10.2012, 14:44 GMT-4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.3a 0 Replies
Please login with a confirmed email address before reporting spam
I am doing a piezoelectric simulation and using a force, I have displaced the piezoelectric cantilever. However, in the results section, I'm not sure which type of strain should I be looking at as there are so many options available. I just want to know the typical strain in the x direction (1-dir) and z-dir (3-dir). Thanks.
Regards,
Lionel
Hello Lionel Wong
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.