Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

On Mapping Mesh Division of Double Electric Layer Direction

Please login with a confirmed email address before reporting spam

I want to draw a mapping mesh in this model, and the requirements are as follows: A mapped mesh with M uniform points along the azimuthal direction and N points along the radial direction is used in the simulation.(M=1200,N=500)the total number of mesh elements is chosen to be 600 000 in the current study. To resolve the detailed information of EDL,extremely fine meshes were created near the cylinder surface.The smallest mesh size near the cylinder surface is 1% ofthe Debye length(Debye length is 0.1nm) and then increases by 3% away from the cylinder. Do you have any good suggestions? Do I need to draw a mesh inside of the circle? My method is like this(2.png、3.png). Is it correct?



0 Replies Last Post 19.07.2023, 08:29 GMT-4
COMSOL Moderator

Hello Tao Zhou

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.