Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametrize time label in plots

Please login with a confirmed email address before reporting spam

In time dependent analysis there is a time label as in the attached. How to turn it into sth like time=T/3, time=T/2 that depends on t/T? Here the time domain t=[0,T], where T is a parameter.



2 Replies Last Post 07.11.2024, 09:08 MEZ
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 06.11.2024, 11:21 MEZ
Updated: 7 months ago 06.11.2024, 11:22 MEZ

Hi,

Yes, with a manual plot title with the Parameter indicator set to Time=T/eval(T/t) you should get that type of label, if the time steps are fractions of T (see the attached screenshot). I would advice against the use of T for the final time if a heat transfer interface with a temperature T is included in the model.

Hi, Yes, with a manual plot title with the **Parameter indicator** set to `Time=T/eval(T/t)` you should get that type of label, if the time steps are fractions of `T` (see the attached screenshot). I would advice against the use of `T` for the final time if a heat transfer interface with a temperature *T* is included in the model.


Please login with a confirmed email address before reporting spam

Posted: 7 months ago 07.11.2024, 09:08 MEZ

Dr Ringh Thank you so much for your help once again.

Dr Ringh Thank you so much for your help once again.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.