Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coil/Magnet Simulation

Posted 25.06.2025, 13:28 GMT-4 Electromagnetics, Low-Frequency Electromagnetics Version 6.2 0 Replies

Gerard McGleenan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am modeling an electro-magnet and comparing the results with some measurements. The results are fairly accurate except as you approach the area close to the boundary between the steel and the air domain.

I am just using a tetrahedral mesh. Is there a particular approach I need to take for this boundary?

0 Replies Last Post 25.06.2025, 13:28 GMT-4
COMSOL Moderator

Hello Gerard McGleenan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content