Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Study

Please login with a confirmed email address before reporting spam

I would like to deform a component and strain it in the deformed state with internal pressure. How do I set up the study, so that these two processes run sequentially. The pressure load is to take place sinusoidal (pulse pressure test).

0 Replies Last Post 18.12.2013, 08:04 GMT-5
COMSOL Moderator

Hello Yasemin Kirli

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.