Sehen Sie, wie die Multiphysik-Simulation in verschiedenen Branchen eingesetzt wird
Multiphysik-Modellierung und -Simulation treiben Innovationen in Industrie und Wissenschaft voran – wie die zahlreichen Anwendungsbeispiele zeigen, die jedes Jahr in den Fachbeiträgen und Postern von Ingenieuren, Forschern und Wissenschaftlern auf der COMSOL Conference vorgestellt werden. Lassen Sie sich von den unten aufgeführten aktuellen Beiträgen inspirieren oder nutzen Sie die Schnellsuche, um eine bestimmte Präsentation zu finden oder nach Anwendungsbereich oder Konferenzjahr/-ort zu filtern.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
Multi-physics simulations of the evolution of cure induced stresses in a viscoelastic thermoset polymeric resin are presented. The viscoelastic material model is implemented with a relaxation spectrum with 34 relaxation time constants. The trends in viscoelastic stresses at different ... Mehr lesen
Steam Generator Test Facility (SGTF) is set up in IGCAR to optimize the design of Steam Generators (SG) for Fast Breeder Reactors. In the SG of SGTF heat exchange takes place from sodium which enters at 525 ºC and leaves at 355 ºC temperature to the water/steam which enters at 235 ºC and ... Mehr lesen
The novel concept of distributing the food super chilled (partially frozen) in order to prolong the shelf life has been suggested in the project. The temperature of the distribution chain is envisaged to be +5C. The suggested application has the following advantages: 1) Partial ... Mehr lesen
Hunting Lodge St. Hubertus is one of the most prominent Dutch buildings from the early twentieth century. An extensive study of wind and wind-driven rain (WDR) was conducted to provide insight into the moisture load of the building facade, using measurements and CFD simulations. COMSOL ... Mehr lesen
In this work, we present simulations of a novel micromachined calorimetric flow sensor using COMSOL Multiphysics. The sensor is based on four germanium thermistors that serve as heat sources and as temperature sensors simultaneously. In operational mode, the heated membrane is cooled by ... Mehr lesen
Temperature and residual moisture content of a stationary Textile in a home tumble dryer are simulated in a 2D model with COMSOL Multiphysics. Moisture migration to the textile surface is modeled in the form of capillary flow and vapor diffusion along with heat transfer in the form of ... Mehr lesen
This paper presents a preliminary analysis of the coupled thermo-hydrodynamics and neutronics of circulating nuclear fuel systems in a nuclear reactor that adopts a molten salt mixture. This flows up through channels in a graphite moderated core and plays the role of both heat generator ... Mehr lesen
The aim of the present work is the formulation of a computational model describing transport phenomena in transient biosolids drying. COMSOL Multiphysics was used to perform the simulations, with two spatial dimensions. After a time step of 0.1 s, we found that the solid reached thermal ... Mehr lesen
Heat and mass transfer involved in drying is studied by using COMSOL 3.4. The effect of air temperature on the performance of the drying process applied to fresh food slices is scrutinized. COMSOL’s flexible formulation is exploited by using special drying kinetics for the substrate, ... Mehr lesen
In this study fluid-dynamical and thermal performance of active chilled beams is investigated by 2D and 3D modelling in COMSOL Multiphysics. Three different typologies of those air conditioning systems are considered. Results, obtained for typical range of variation of operational ... Mehr lesen
