Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
We simulate a Capacitive Micromachined Ultrasound Transducer (CMUT) using COMSOL Multiphysics® software. The CMUT is an electromechanical system, therefore, we couple the physics of electrical and structural mechanics to describe its dynamics. We obtain the distributions of the electric ... Mehr lesen
Magnetic Particle Imaging (MPI) is a new imaging technology based on the non-linear magnetisation of magnetic nanoparticles which can be used as a tracer material. In a high speed 1D MPI Device, a sinusoidal signal containing a single frequency generate a time-varying magnetic field via ... Mehr lesen
Micro Mirrors is a versatile device which has been gaining popularity and this finds application in fields such as optical switching, display and in medical fields for non-invasive imaging. A thermally actuated mirror moves in either positive or negative directions of x and y. The ends ... Mehr lesen
Introduction: Chronic arterial hypertension (HTN) is a pathological condition characterized by prolonged high level of arterial blood pressure causing major damages to several human body apparata. Renal sympathetic denervation (RDN) has been found to effectively reduce systemic blood ... Mehr lesen
Magnetorheological Finishing (MRF) is one of the precision finishing processes in which magnetic field is used to drive abrading forces for Finishing 2D and complex 3D surfaces. In this paper, Ball End Magnetorheological Finishing (BEMRF) has been analyzed for fluid behaviors under the ... Mehr lesen
Normal conducting cavities are typically used in the front end of proton accelerators to get the beam accelerated to velocities approximately a few tenths of the speed of light, where superconducting cavities can then be used to accelerate the beam to the speed of light. The warm part of ... Mehr lesen
The paper presents the numerical analysis of quench propagation in a DH magnet wound with a commercially available MgB2 wire in a fiber-glass composite matrix and operating at 20 K. The quench is induced by a small heater located on the first layer of the magnet close to the peak field ... Mehr lesen
Accelerometers are successfully commercialized MEMS devices. COMSOL Multiphysics® has been used in the modeling, simulation and optimizing of this design. The piezoresistive accelerometer is made up of a square proof mass with flexures supporting it. The piezoresistors are placed near ... Mehr lesen
Project X is a proposed proton accelerator complex at Fermilab. The CW LINAC is based on five types of resonators operating at three frequencies: half-wave, spoke, and elliptical. The low beam current for the CW operation of Project X requires cavities to operate at a high loaded Q and, ... Mehr lesen
The plasma reactor with radial line slot antenna (RLSATM), a planar microwave plasma source, is used in etch and deposition technology, typically in reactive rich gaseous environments and for processes that are sensitive to plasma damage. Besides a strict uniformity control, the plasma ... Mehr lesen