Veröffentlichungen und Präsentationen

Schnellsuche

Ressourcen

Whitepaper

Sehen Sie, wie die Multiphysik-Simulation in verschiedenen Branchen eingesetzt wird

Multiphysik-Modellierung und -Simulation treiben Innovationen in Industrie und Wissenschaft voran – wie die zahlreichen Anwendungsbeispiele zeigen, die jedes Jahr in den Fachbeiträgen und Postern von Ingenieuren, Forschern und Wissenschaftlern auf der COMSOL Conference vorgestellt werden. Lassen Sie sich von den unten aufgeführten aktuellen Beiträgen inspirieren oder nutzen Sie die Schnellsuche, um eine bestimmte Präsentation zu finden oder nach Anwendungsbereich oder Konferenzjahr/-ort zu filtern.

Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an

Suchbegriff:

Modeling Ferrofluid Flow in an Annular Gap Moving with Reciprocating Shaft

Y. He[1], R. Nilssen[1]
[1]Department of Electric Power Engineering, Norwegian University of Science and Technology, Trondheim, Norway

Ferrofluids have been successfully used in the seals for rotary shafts, but few studies focus on the reciprocating motion seals. Since the completely different operational regimes, previous experiences on the rotary motions could not be directly applied on the cases for reciprocating ... Mehr lesen

Looking for the Origin of Power Laws in Electric Field Assisted Tunneling

H. Cabrera[1], D.A. Zanin[1], L.G. De Pietro[1], A. Vindigni[1], U. Ramsperger[1], D. Pescia[1]
[1]Laboratory for Solid State Physics, ETH Zurich, Zurich, Switzerland

A sharp tip approached perpendicular to a conducting surface at subnanometer distances and biased with a small voltage builds a junction across which electrons can be transferred from the tip apex to the nearest surface atom by direct quantum mechanical tunneling. Such a junction is used ... Mehr lesen

Detector and Calibration-source Models for the SAFARI Detector Test Facility

M. Audley[1], G. de Lange[1], C. Bracken[2]
[1]SRON Netherlands Institute for Space Research, Groningen, The Netherlands
[2]National University of Ireland, Maynooth, Ireland

SAFARI is a far-infrared imaging spectrometer for the Japanese satellite observatory SPICA. SAFARI covers the wavelength range 34—210 μm (1.4—8.8 THz) using Transition-Edge-Sensor (TES) bolometers. We have built a test facility to qualify and characterize the SAFARI focal plane units ... Mehr lesen

Sub-Millimetric Vacuum Electron Gun Design and Characterization

A. Leggieri[1], G. Ulisse[1], F. Di Paolo[1], F. Di Paolo[1], A. Di Carlo[1]
[1]University of Rome "Tor Vergata" - Department of Electronic Engineering, Rome, Italy

This paper presents the design of an electron gun that could be employed for vacuum tubes operating in the THz range. In this context, vacuum tubes one of the main difficulties in the realization of THz vacuum tube is the design and the realization of the electron gun. Since the ... Mehr lesen

Using the Electrical Field Analysis for Assessment of the Influence of Paper Insulation on Discharge Initiation in Oil

P. Rozga[1], D. Hantsz[1]
[1]Technical University of Lodz, Lodz, Poland

Conclusions about the influence of paper insulation on the electrical discharge initiation in mineral oil may be drawn on the basis of experimental studies. However, in some cases, these conclusions may be supported by electrical field analysis. Determination of maximum values of ... Mehr lesen

A Model of Noninvasive Radiofrequency Tissue Heating

L. Rems[1], D. Miklavcic[1]
[1]University of Ljubljana, Faculty of Electrical Engineering, Ljubljana, Slovenia

Noninvasive radiofrequency (RF) tissue heating is frequently used for skin tightening and facial wrinkle reduction as alternative to invasive surgical procedures. However, to ensure a safe and efficient therapy, the temperature of the skin and the subcutaneous tissue must be controlled ... Mehr lesen

Development and Optimization of a Microfluidic Device for Magnetic Field Induced Cell Separation

L. Helmich[1], A. Hütten[1]
[1]Bielefeld University, Bielefeld, Germany

Besides conventional laboratory analysis methods, so called micro-total-analysis devices (µTAS) have gained great interest during the last decades. In this work we demonstrate a mechanism for the separation and selection of medical samples that can be applied within these µTAS devices. ... Mehr lesen

Anisotropic Heat Transfer in Orthocyclically Wound Coils

T.L. van Vuure[1]
[1]Tecnotion B.V., Almelo, The Netherlands

Tecnotion produces linear motors for the high tech automation and semiconductor markets. Orthocyclically wound coils give the best performance because the largest number of windings can be packed into a given volume, as opposed to "wild winding", where the windings fall where they may. ... Mehr lesen

The Swelling Responsiveness of pH-Sensitive Hydrogels in 3D Arbitrary Shaped Geometry

K. J. Suthar[1], D. C. Mancini[2], M. K. Ghantasala[3]
[1]Advanced Photon Source, Argonne National Laboratory, Argonne, IL, USA
[2]Physical Sciences and Engineering, Argonne National Laboratory, Argonne, IL, USA
[3]Department of Mechanical Engineering, Western Michigan University, Kalamazoo, MI, USA

The pH-sensitive hydrogels are responsive to the pH of surrounding solution, which often resemble to biomaterials. Recently, pH-sensitive hydrogels are widely used in various devices as sensing media. We present the simulation of swelling characteristic of 3D-arbitarary-geometry, pH ... Mehr lesen

Improving Detection Sensitivity for Nanoscale Targets Through Combined Photonic and Plasmonic Techniques

G. Zhang[1], Y. Zhao[1]
[1]Clemson University, Clemson, SC, USA

Photonic technique such as the whispering gallery mode (WGM) is often used for detection of small particles like bacteria and viruses. It offers good detection sensitivity and is advantageous over other detection techniques because the detection can be label free. However, the detection ... Mehr lesen

Erste

1491–1500 of 1762

Letzte