Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
In this paper we present a summary of our work on numerical modeling of superconductors with COMSOL Multiphysics®. We discuss the two models we utilized for this purpose: a 2-D model based on solving Maxwell equations and a 1-D model for thin conductors based on solving the integral ... Mehr lesen
COMSOL Multiphysics has been widely used to model the near and far-field electromagnetics (specifically, transmission and reflection spectra) of gold and silver nanoantenna arrays. We use a moving 3D mesh, thus preserving the DOF number and simply morphing the structure of the mesh ... Mehr lesen
A three phase transformer with very low harmonic pollution transferred back to power line is here presented. In fact, thanks to the described setup, intermediate harmonics (5th and 7th) are not going out back to the power line feeding the primary. These results has been extensively ... Mehr lesen
Steam generators (SGs) are used in CANDU® nuclear reactors as heat exchangers to convert water into steam using heat generated in the reactor core. Ferrous trefoil broach support structures prevent excessive vibration of thousands of SG tubes. A probe that uses pulsed eddy current (PEC) ... Mehr lesen
We demonstrate the use of COMSOL Multiphysics with MATLAB to model signal generation in wide-bandgap semiconductor radiation detectors. A quasi-hemispherical detector design is compared with a simple, planar detector. Results show that the quasi-hemispherical design can simply and ... Mehr lesen
Introduction: The dual electromagnet configuration of Active Magnetic Levitation system (AML) where the electromagnets are locate opposite to each other, constitutes and single axis of the Active Magnetic Bearing. The same configuration can be used to test the single electromagnet AML ... Mehr lesen
Linear wave propagation through inhomogeneous structures of size R?? (Fig.1) is a computationally challenging problem, in particular when using finite element methods, due to the steep increase of the number of degrees of freedom as a function of R/?. Fortunately, when the geometry of ... Mehr lesen
The design of a magnetic resonance imaging (MRI) RF coil using finite element method-based analysis is an essential part of a multi-year research project at the National Institute of Standards and Technology, Gaithersburg, Maryland, where the goal of the project is to develop a “phantom” ... Mehr lesen
Prototype Fast Breeder Reactor (PFBR) is a 500MWe, sodium cooled, pool type, mixed oxide (MOX) fuelled reactor. Sodium flow measurement in various loops of the reactor is of prime importance from the operational and safety aspects. To measure the flow of electrically conducting sodium in ... Mehr lesen
Metallic nanoparticles (NPs) are nowadays used in various areas of biology, chemistry or physics. Focused laser beams, optical tweezers, may be used to manipulate such NPs. However, experimental studies showed that there is a discrepancy between their predicted and observed behavior. ... Mehr lesen