Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Automatically remesh deformed configuration during a parametric sweep

Posted 06.06.2012, 15:07 GMT-4 Mesh 0 Replies

Ben Thornton
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to run a parametric sweep on an axis symmetric fluid structure interaction problem. The problem involves fluid flowing from an inlet with a defined pressure. The fluid flows over an obstacle causing it to deform and then flows to the outlet which has a zero pressure condition. I am sweeping the inlet pressure from 0.1 to 1000 psi. The problem that I am having is that at around 200 psi my mesh quality drops because the deformation of the obstacle causes the nearby elements to stretch excessively. The geometry of my problem prevents me from using the sliding boundary element technique described in www.comsol.com/support/knowledgebase/970/.

I am wondering if there is a way to automatically remesh at a certain parameter value or when the mesh quality drops below a certain value.

I have attached a capture of my geometry.
0 Replies Last Post 06.06.2012, 15:07 GMT-4
COMSOL Moderator

Hello Ben Thornton

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content