Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric Sweep - Comsol 4.0a

Please login with a confirmed email address before reporting spam

Hi:

Under the Parametric Sweep Setting, I am not able to write in the
parameters name. I click the add button but I am still not able
to write in the names. How do I go about that?

Best Regards
PJ

2 Replies Last Post 26.07.2010, 12:03 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26.07.2010, 11:32 GMT-4
Hi

in the new 4.0a version you can only add in predefined "Parameter" values. So define the name and in itialise it first up in the Definition node, then use the "+" to add a list of names to select from

--
Good luck
Ivar
Hi in the new 4.0a version you can only add in predefined "Parameter" values. So define the name and in itialise it first up in the Definition node, then use the "+" to add a list of names to select from -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26.07.2010, 12:03 GMT-4
Hi Ivar:

Thank you very much. Works like a charm

Best regards,
PJ
Hi Ivar: Thank you very much. Works like a charm Best regards, PJ

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.